This year we were invited once again to run a TinyGo workshop at GopherConEU. I can't thank Natalie, Donna and the rest of the organizers and volunteers enough for making it happen. After two years we went back to Freestyle Krunchberg Futsaal Krutzberg Festsaal Kreuzberg. One day I&

What if your development board just wasn't big enough? That's the question I answered by building a fully functional, 15× scale replica of the Seeed Studio XIAO ESP32-C3 - 3D printed, wired up, and ready to use as at the GopherCon EU 2026's hacksession.

My daughter's life now revolves around K-Pop Demon Hunters, Huntrix, BTS, BlackPink,... so naturally, since we're getting into the K-Pop culture, we discovered the existence of the "K-Pop lightsticks" or "army-bombs". Do you know about the Taylor Swift LED bracelets? Well this

On October 12th, the first-ever TinyGo Conf happened in Tokyo, Japan. I planned to write about it sooner, but I did so many things during my trip that I didn't have the time nor strength to do it until now. It was only possible thanks to the amazing

GopherCon Europe 2025 is over, part of TinyGo team went there to do a TinyGo HackSession as previous years, plus Ayke had a talk about multicore support too!. I can say it was amazing and I had a blast there: meeting old friends, making new ones and a bunch of

Este fin de semana se celebró un emocionante taller de TinyGo en el IES Universidad Laboral de Toledo, con la participación de estudiantes y profesores del centro. La iniciativa, organizada por Manuel de la Peña, colaborador del GDG Toledo y miembro del proyecto TestContainers for Go, permitió a los asistentes

The English version of the documentation used in the TinyGo Keeb Tour workshops is finally available. I've just translated the guide made by sago35. You could find it here https://github.com/tinygo-keeb/workshop/blob/main/README_EN.md

The TinyGo Keeb Tour 2024 & 2025 is a series of workshops held all around in Japan about the TinyGo Keeb zero-kb02, which is a DIY keyboard whose firmware is written in Go (TinyGo). The first half of the workshop is physically building the keyboard (a bit of soldering, putting

I have made a few changes on the GopherBadge SHOP that will simplify my work behind scenes. Until now, I used to duplicate the items, so I could offer the same product without shipping cost added. This means I needed to maintain two versions of the same content, stock and